targets cone angle 是怎么使用的? [查看原帖]
共有评论: 2  每页显示: 10  页码: 1/1  【论坛浏览】 【论坛回复】
首页  上页  1  下页  尾页
2楼  gds
2011/7/8 21:16
[i=s] 本帖最后由 gds 于 2011-7-8 21:19 编辑

给你个官方的例子:


Broadband AR for a Cone of Light
Here we consider a coating on glass that reflects only 0.5% of a cone of light for a range of wavelengths from 420 to 680 nm. The cone axis is normal to the glass. The cone has an F-number of 0.778, which means the half-angle is 40 degrees. An uncoated glass surface reflects 4.4% of this cone of light. We use a feature new to version 3.5: cone-angle targets. As optimization targets we use
R < 0.5% for wavelengths 420, 425, 430,..., 680 and for a 40-degree cone

In TFCalc, these targets are easy to enter by using the "Generate Cone Targets" command on the Options menu of the "Targets - Cone Angle" window. We use TFCalc's needle/tunneling optimization to design the coating from "scratch". That is, we begin the design process with a single thin layer of TiO2 and allow TFCalc to increase the thickness and number of layers in the design. TFCalc finds a 6-layer design in a few minutes. The performance of this design is shown below. The little circles indicate the optimization targets.


Here is the design, starting with the layer closest to glass, and with thicknesses given in nm:
TIO2 11.04
SIO2 44.43
TIO2 34.99
SIO2 28.25
TIO2 30.46
SIO2 104.92

3楼  280870377
2012/9/7 10:35
多角度的?还是圆锥角啊?
首页  上页  1  下页  尾页

验证码:        
推荐文章
推荐文章
© 2021 光学薄膜信息网    设置底部链接
Powered by DIY-Page 8.3